Hydrolic sounds (syntetised digital sound from radio speaker that could be turn On/Off) would give back that lost sens that CAT And John deere didnt give importance.

Exemple: when a pro operator check the right side of the blade and want to do a correction on the left side without having to look at it, the Sound would give him the feeback of how much force he pushed the joystic.

A another way to increase prodution of the Gp serie

small like a live roll on trailers .sort of like a rolling pin.that mounts to the ripper .packing gravel after grading seals it ,stops the washboard.

ive run a motorgrader for 5 yrs id like to see more room inside the cab and also a 11 valve spool to acomedate a snow wing im runing a 772ch right now and the cab is small and hard to see out of id like to try out the the GP series

Holding the right or left button 3 or 4 second shoulds bring the slopes info into the Deere computer screen because it's important to know the Mainfall Info when you check the slope on all the 30 feets long of the machine. It could be program for other finction too like Slope memory's or other infos.

Gp motor grader. Holding (increament & decreament) button for 3 seconds should record blade slope actual position into the desired slope. Instead of pushing the button 40 times to go back from 6% to 2% every times.

Every pass that we start would faster and production capability of the GP would increase directly.

Just send us an update

tracks on graders so to stop the bounce or gallop.

Would like to see a softer cushion under the legs on the seat of the grader.

It comes with this

14 Ft. x 27 In. x 1 In. (4.27 M x 686 mm x 25 mm) with 8 In. x 3/4 In. (203 x 19 mm) Cutting Edge and 5/8 in. (16mm) Hardware

BUT the circle is not paralell to the ground with that specification, it's is better with a 10'' cutting edge! now you dont need to compensate when turning the circle.

The actual circle rotation sensor of the GP motor grader does not work well with 3D UTS Machine control. when the Mainfall sensor is more than 10 % hills, the rotation sensor doesnt give enough precision to make the accuracy (10mm) of the slope controlled sides .

So a new rotation sensor model more accurate and more tight would be important for those who work with Trimble 3d or Topcon 3d control.

That's an emergency!

Graders - Would like to see a full width rear window shade, also try mounting a light on the top of the lift cylinders...it makes a world of difference, also rear back up lights could be outside or on top of the frame to give clearance around the rear ripper.